Detailed Product Description

1.  Product characteristics

Three component water based conductive epoxy self levelling .

UNEPOX SLCWB  is consists of 100% solids epoxy resin filled with a variety of graded quartz and silica and carbon fibres that can be modified to create the best design mix for ideal performance. A wide selection of finish coats is available for varying exposure requirements.  

2.        Product use

These systems are the answer for both new construction and renovated areas that required to electrical conductivity, and can be installed over most sound floors.

2.1.Uses areas :

Processing ,electrical equipments rooms, electronic production industry, high voltage rooms, TV studios, Computer rooms, hospitals, etc

3. Product properties

UNEPOX SLCWB when cured, produces a dense, non-porous floor that is chemical and dirt resistant. UNEPOX SLCWB is a seamless, low maintenance system exhibiting high wear and durability for light to medium traffic areas.

UNEPOX SLCWB may be sealed with a top coat to further enhance abrasion resistance, gloss retention, and non-skid properties.

UNEPOX SLCWB is a broadcast system of selected aggregates. The slurry system is a seamless, low maintenance system exhibiting high wear, durability, and impact resistance for medium traffic areas. To fill in pores and secure the aggregate, a second epoxy coating is applied producing a textured, skid resistant floor.

4. Color Selection

UNEPOX SLCWB is available in a variety of RAL Colour Chart.

Custom colors are available subject to laboratory approvals, minimum quantities, lead time for production, and increased cost.BOYTEM TECH SERVICE DEPARTMENT are ready to assist.

5.        Technical data

BASIC DATA(for mixed product at 20 C)

Mass density                     :approx.1,60 g/cm?

Solids content          :approx. 76 % by volume

Touch after dry                 :12 hours

Overcoating interval           :Min.24 hours, Max.48 hours

Full cure after                            :7 days

Electrical conductivity         :10-⁵    ( DIN 51953)

Corrosion resistance(et loss

(mg/100 cycles )               :156

Fiction Coefficient             :0,28

Compression resistance

(28 days ) ( N/mm2)        :54,2

Tensile Strength

(28 days ) ( N/mm2)        :12,7

Streching Resistance

(28 days ) ( N/mm2)        :23,2

5.1.Curing Time:

8-16 hours after application of seal coat for light traffic.

24-36 hours after application of seal coat for heavy traffic.

5.2. Chemical Resistance:

For specific information, consult BOYTEM TECH SERVICE DEPARTMENT for best choice.

5.3. Theoretical spreading rate

1m2 / 3,2 kg for 2 mm average dry coating thickness